Kubota water pump
- Interchanges
- 1C010-73030 · 1C010-73032
- Engine
- V3300
Every unit is measured and leak-tested before packing.
15321-72910 is the Kubota OE number for this cooling water pump. Match it against the number on your old pump or in the parts book — our replacement follows the OE dimensions.
This pump was designed for Water house 6 hills; WATER THERMOSTAT.
Match your engine model to the list and the pump will fit without rework.
| Parameter | Value |
|---|---|
| OE number | 15321-72910 |
| Fits brand | Kubota |
| Mounting hole position | Aligned to OE mounting points |
| Installation of water pipes | Water pipe fitted complete, no deformation |
| Air tightness testing | Leak-tested at 0.1 MPa negative pressure |
| Appearance Ⅰ | Neutral finish, no third-party logos |
| Appearance Ⅱ | Clean surface: no dirt, rust or paint peeling |
| Assembly rotation | Turns freely by hand, no sticking or noise |
| Net weight | 0.45 kg |
| Packing | 16 pcs/ctn, 9.50 kg gross |
Each pump is packed individually; a master carton holds 16 pieces at 9.50 kg gross.
Every pump leaves the line after a 0.1 MPa negative-pressure test. No leaks, no exceptions.
A hand-rotation check closes out the inspection: the shaft must turn smoothly and quietly.
What vehicles or engines does 15321-72910 fit?
15321-72910 fits Water house 6 hills and WATER THERMOSTAT engines. It is a Kubota application water pump, and our aftermarket unit replaces it directly.
How much does the 15321-72910 water pump weigh?
One pump weighs 0.45 kg net. A full carton of 16 pieces comes to 9.50 kg gross.
What should I check before replacing the 15321-72910 water pump?
Look for coolant seepage at the weep hole, bearing noise and pulley wobble on the old unit. Any of these means the pump is due; replace the coolant and check the belt at the same time.
How do I confirm 15321-72910 is the pump I need?
Check the OE number stamped on your old pump or in the parts book, then compare engine model and pulley height with the spec table on this page. If anything is unclear, send us a photo of the old unit.
Send the OE number, your quantity and your destination port — we reply with fitment confirmation and a quote.
The inspection record travels with the carton. If a pump fails any check, it does not leave the bench.
Sealed and pulled to −0.1 MPa. No leakage detected, or the unit is rejected.
Turns freely by hand — no clamping stagnation, no abnormal noise.
No supplier logo, no dirt, rust or paint peeling on the casting.
Hole positions checked against the original for precise alignment.
The OE number is already in the email subject. Add your quantity and destination — we reply with unit price, MOQ and lead time within one working day.
No form to fill in. The OE number is already in the subject line — add quantity and destination port, and the desk replies within one working day.
sales@hanchitradecn.comOpens your mail app with this OE number filled in. Prefer to write from a different address? Send to the same mailbox.